[Ipe-discuss] Unable to change grid size and snap angle
OC
oc-spam66 at laposte.net
Fri Jun 29 23:06:13 CEST 2012
Hello,
I was quite distressed because I couldn't change the grid size and snap
angle in my document. The toolbar only displayed "16pt" and "45 deg" and
nothing else was available.
I finally understood that the problem happened because my document was
converted from an old Ipe6 PDF file with ipeextract / ipe6upgrade. The
resulting IPE file did not have any <gridsize> nor <anglesize> definitions.
A solution was to copy-paste the drawing from the "bad" document window
to a blank Ipe window and save as a new file. The resulting document
could be used satisfactorily.
I write this in case other people would have the same problem and look
for a solution.
Maybe ipe6upgrade could be improved so as to add defaults for <gridsize>
and <anglesize>.
Best regards,
O.C.
More information about the Ipe-discuss
mailing list